Sensors, Vol. 19, Pages 873: Flexural Capacity and Deflection of Fiber-Reinforced Lightweight Aggregate Concrete Beams Reinforced with GFRP Bars (Sensors)

Adding fibers is highly effective to enhance the deflection and ductility of fiber-reinforced polymer (FRP)-reinforced beams. In this study, the stress and strain conditions of FRP-reinforced lightweight aggregate concrete (LWC) beams with and without fibers at ultimate load level were specified. Based on the sectional analyses, alternative equations to predict the balanced reinforcement ratio and flexural capacity for beams failed by balanced failure and concrete crushing were established. A rational equation for estimating the short-term stiffness of FRP–LWC beams at service-load levels was suggested based on Zhu’s model. In addition, the contribution of the steel fibers on the short-term stiffness was quantified incorporating the effects of FRP reinforcement ratio. The proposed short-term stiffness model was validated with measured deflections from an experimental database for fiber-reinforced normal weight concrete (FNWC) beams reinforced with FRP bars. Furthermore, six glass fiber-reinforced polymer (GFRP)-reinforced LWC beams with and without steel fibers were tested under four-point bending. Based on the test results, the proposed models and procedures according to current design codes ACI 440.1R, ISIS-M03, GB 50608, and CSA S806 were linked together by comparing their predictions. The results showed that increasing the reinforcement ratio and adding steel fibers decreased the strain of the FRP bars. The flexural capacity of the LWC beams with and without steel fibers was generally underestimated by the design codes, while the proposed model provided accurate ultimate moment predictions. Moreover, the proposed short-term stiffness model yielded reasonable estimations of deflection for both steel fiber-reinforced lightweight aggregate concrete (SFLWC) and FNWC beams.