Remote Sensing, Vol. 10, Pages 1997: Reconstruction of Three-Dimensional Images Based on Estimation of Spinning Target Parameters in Radar Network (Remote Sensing)

A high-resolution three-dimensional (3D) image reconstruction method for a spinning target is proposed in this paper and the anisotropy is overcome by fusing different observation information acquired from the radar network. The proposed method will reconstruct the 3D scattering distribution, and the mapping of the reconstructed 3D image onto the imaging plane is identical to the two-dimensional (2D) imaging result. At first, the range compression and inverse radon transform is employed to produce the 2D image of the spinning target. In addition, the process of mapping the spinning target onto the imaging plane is analyzed and the mapping formulas which are to map the point onto the 2D image plane are derived. After the micro-Doppler signature about which every reconstructed point in 2D imaging result is extracted by the Radon transform, the extended Hough transform is adopted to calculate an important parameter about the micro-Doppler signature, and the 3D image reconstruction model for the spinning target is constructed based on the radar network. Finally, the algorithm for solving the reconstruction model is proposed and the 3D image of the spinning target is obtained. Some simulation results are given to illustrate the effectiveness of the proposed method, and results show that the mean square error (MSE) relatively holds a steady trend when the signal-to-noise ratio (SNR) is higher than −10 dB and the MSE of the reconstructed 3D target image is less than 0.15 when SNR is at the level of −10 dB.