IJERPH, Vol. 19, Pages 12562: Grafting of R4N+-Bearing Organosilane on Kaolinite, Montmorillonite, and Zeolite for Simultaneous Adsorption of Ammonium and Nitrate (International Journal of Environmental Research and Public Health)

Modification of aluminosilicate minerals using a R4N+-bearing organic modifier, through the formation of covalent bonds, is an applicable way to eliminate the modifier release and to maintain the ability to remove cationic pollutants. In this study, trimethyl [3-(trimethoxysilyl) propyl] ammonium chloride (TM) and/or dimethyl octadecyl [3-(trimethoxysilyl) propyl] ammonium chloride (DMO) were used to graft three aluminosilicate minerals, including calcined kaolinite (Kaol), montmorillonite (Mt), and zeolite (Zeol), and the obtained composites were deployed to assess their performance in regard to ammonium (NH4+) and nitrate (NO3−) adsorption. Grafting of TM and/or DMO had little influence on the crystal structures of Kaol and Zeol, but it increased the interlayer distance of Mt due to the intercalation. Compared to Kaol and Zeol, Mt had a substantially greater grafting concentration of organosilane. For Mt, the highest amount of loaded organosilane was observed when TM and DMO were used simultaneously, whereas for Kaol and Zeol, this occurred when only DMO was employed. 29Si-NMR spectra revealed that TM and/or DMO were covalently bonded on Mt. As opposed to NO3−, the amount of adsorbed NH4+ was reduced after TM and/or DMO grafting while having little effect on the adsorption rate. For the grafted Kaol and Zeol, the adsorption of NH4+ and NO3− was non-interfering. This is different from the grafted Mt where NH4+ uptake was aided by the presence of NO3−. The higher concentration of DMO accounted for the larger NO3− uptake, which was accompanied by improved affinity. The results provide a reference for grafting aluminosilicate minerals and designing efficient adsorbents for the co-adsorption of NH4+ and NO3−.